**Prerequisite: ** Must have taken the 2-day Fall Protection Equipment Inspection course within the past 3 years.
Details
• relevant legislation, regulations, CSA Standards and manufacturers recommendations regarding the detailed inspection and requirements for Fall Protection and Rescue equipment.
• How to locate the information and procedures to determine the requirements for periodic inspection of all specific fall protection equipment used by the company or organization.
• hands-on inspection and identification of defects and damage to a variety of Fall Protection equipment, but not limited, to the equipment listed below:
• anchor connectors; Cable, Synthetic; Beam Clamps; Rail Clamps; Hooks
• full body harnesses
• lanyards
• personal energy absorbers
• snap hooks
• carabiners
• self-retracting lifelines and lanyards
• vertical lifelines
• rope grabs and fall arresters.
• shackles
• beam clamps
• block and tackle type rescue systems
• descent control devices
• positioning systems
• pre-engineered, temporary horizontal systems
• information regarding the frequency of detailed inspections
• Completion and recording of inspections in a manner which includes the detailed information required to ensure equipment may be traced while in service.
• trainee qualification
• Evaluation of the trainee’s knowledge retention by both a written test for the theory and the review of documented inspections for the practical portion.
Instructions
Trainees can bring their own PPE for inspection.
Instructions
**Prerequisite: ** Must have taken the 2-day Fall Protection Equipment Inspection course within the past 3 years.
Safety Footwear, tool belt, hard hat, gloves & glasses are required.
Course Length: 1 Day (8 Hours)
Courses run 7:45AM – 3:45PM daily at the location you have selected.
Please look for "Student" parking stalls on arrival at 1099 King Edward St.